China bamboo flooring | Access floor | Raised floor » Uncategorized

China bamboo flooring on engineered flooring?

admin — Mon, 20 Jul 2009 15:50:12 +0000

Someone has a house installed with engineered flooring(E). And he was going to replace it with China bamboo flooring(B). But it is very difficult to

get rid of the engineered planks. He wonders if he can install B on E.

Our reply:

B can be fitted on any firm, dry and flat place. If the engineered planks in the house meet these requirements, you can install B on the tiles. The thickness of B is normally 14mm or 15mmThe height between the door and floor is normally less than 14mm and more than 6mm. The thickness of floor will be over 22mm if some subfloor is installed on the ceramic tile and under B. So you need to replace the former door with a a “shorter” one to make door work well if B is installed on E. It will much more convenient if China bamboo flooring is just installed on the corridor and there is no door neighboring to the channel.

Type 6945 access floor

admin — Fri, 22 May 2009 08:40:45 +0000

The panel size of type 6945 access floor is 500*500*33mm. The panel is made up of cold rolled steel sheet and foamed cement. There are 2 cable wires on the double sides of the panel. The edge of the panel is covered with 4 pieces of PVC strips. The strong and weak electricity is separated with different codes on the surface of the cable. The top of the panel is covered with PVC tiles. The height of the pedestal can be adjusted between 140mm and 320mm. Its concentrated load is 5000N. And its uniform load is 20100N/M2. The weight of the floor is 16kgs. It is widely used in large and middle sized classroom and computer room.

Type 6925 raised floor

admin — Fri, 15 May 2009 11:17:54 +0000

The top and bottom of the panel of type 6925 raised floor are steel sheet. The surface of the top steel sheet is coated with conductive epoxy resin. The panel is filled with foamed cement. There are lock hole in the each corner at the bottom of the panel. The panel of type 6925 raised floor is directly locked with pedestal. No stringer is needed. The panel is covered with oak colored PVC tile. The tile is 3mm thick. Type 6925 raised floor is fireproof, waterproof, corrosion proof and dustproof. It’s concentrated load is 880lb. It is widely used in bank, hospital, Mobile communication room and computer lab.

Type 6123 raised perforated floor

admin — Thu, 02 Apr 2009 07:15:56 +0000

The panel of type 6123 raised perforated floor is die-cast with aluminum material. So the panel is handy, light, strong impact resistant, waterproof and strong anticorrosion. The stringers under the panel prevent magnetic disturbance and improve the anti-earthquake proof performance. This type of perforated floor is supported with corner-lock freestanding understructure system. Its pedestal is with aluminum head. The ribs(axles) are placed in the tube of pedestal to improve its loading performance. Its axle loading is around 7200kg with the pedestal height of 70cm. The open ratio can be between 18% and 55% to meet various perforated purpose. It is widely used at computer room, high grade classroom, high grade hotel and telecommunication center.